Brings a shroud's or stay's end round a deadeye in its score and seizes it back on itself with throat, quarter and end seizings, so that the shroud can then be tensioned by a lanyard passing between two deadeyes.
Tar the deadeye's outer groove (score) well and place it on the shroud at the marked point, allowing for the stretch the shroud will take when it is set up.
Take the working end of the shroud round the deadeye in its score and bring it up beside the standing part; let it cross the standing part and lie on the inboard side, and keep the lay of the rope closed while you work.
Heave the working end taut round the deadeye; Brady does this with a strand and iron bolts rigged as a kind of Spanish windlass, or with a jigger tackle in the loft.
Right above the deadeye, put on a throat seizing that holds both parts of the shroud together.
Higher up, add a quarter or round seizing, and a smaller end seizing near the tip of the working end.
Fixing a deadeye, which a lanyard will later set up, firmly to the foot of a shroud or stay without letting water into the rope.
When
Unknown; Ashley thinks the deadeye was probably bound in with a round seizing in the 1500s and 1600s, while American ships have favoured the throat seizing since the mid-1700s; the oldest book consulted is Lever's Sheet Anchor (Ashley dates it to 1808).
Who devised it
Unknown.
Where the name comes from
The sources do not explain the phrase 'turning in'; Luce says the 'cutter-stay fashion' takes its name from the forestays of cutters.
Its story
On sailing ships the shrouds that hold the mast from the sides are tensioned by deadeyes, flat wooden blocks with three holes fixed to their lower ends: a lanyard running back and forth between two deadeyes works like a tackle. According to Ashley, in the 1500s and 1600s the deadeye seems to have been bound to the shroud with a round seizing, whereas American vessels have favoured the throat seizing from the mid-1700s on. Luce's 1866 textbook for the U.S. Naval Academy quotes the instructions of the British author Boyd and says they run against what American seamen actually do; it also explains that the 'cutter-stay' fashion came from the forestays of cutters, where a sail was hoisted on that stay and this fitting let it come down cleanly. The same book reports trials with three shrouds cut from one rope: the spliced one failed first, the cutter-stay one next, while with the old throat-and-end seizings the rope itself broke at its full strength. Wikipedia notes that turnbuckles replaced deadeyes once wire rigging became common, and that with synthetic rope some boats use them again.
On boats whose shrouds are set up with turnbuckles and have no deadeyes; nor is this throat-seizing method used for wire rigging (Nares says a racking seizing must be used there).
Weakness
The place where the shroud bends round the deadeye and lies under the seizings is open to chafe: Brady writes of shrouds condemned for wear at that spot, and if the rope's lay opens up, water gets in.