Binds two ropes together, or two lengths of the same rope, so they cannot slip, using figure-of-eight turns between the parts, riding turns over them and crossing turns through the middle; described for wire rigging and for places where only one part takes the load.
Lay the two parts to be seized side by side and splice an eye into one end of the seizing line.
Take the first turn round both parts together, as in a round seizing, then pass the line between the two parts.
Pass the remaining turns in a figure-of-eight, the line going back and forth between the parts and round each in turn; leave enough space between turns for a riding turn to lie (Aldridge: usually thirteen turns).
Tuck the end under the final turn, then take riding turns round both parts, laying them in the spaces between the figure-of-eight turns as you work back towards the eye.
After the last riding turn, bring the end up between the two parts and take the crossing turns lengthwise along the seizing, in the groove between the parts; Aldridge locks them with a clove hitch in the middle of the seizing, between the sixth and seventh turns.
Secure the end firmly; Aldridge closes the seizing with a crown and wall knot, the finish he gives his other seizings too.
Holding two parts together so they cannot slip where only one part carries the load; for Nares, seizing wire rigging and turning in deadeyes; for Riesenberg, binding a tackle fall's two parts to each other.
When
Unknown; the term 'racking turns' appears in Dana (1847) and the name 'racking seizing' in Brady's The Kedge-Anchor (1852 edition; first published 1847); a drawing appears in the 1877 edition of Nares's Seamanship.
Who devised it
Unknown.
Where the name comes from
For Smyth, 'to rack' is to bind two ropes to each other with crossing turns, known as racking; the seizing is named after these turns.
Its story
A racking seizing binds two ropes together, or two lengths of the same rope, with turns that pass back and forth between them in a figure-of-eight. Nares's Seamanship (1877) recommends it for wire rigging and for places where only one of the two parts takes the load; he adds that it had recently been adopted for turning in deadeyes, calls it clearly the right seizing for that job, and says wire rigging requires it. In Smyth's sailor's dictionary of 1867, 'to rack' means binding two ropes to each other with crossing turns, and Brady's The Kedge-Anchor (first published 1847; the 1852 edition was consulted) uses 'racking a fall' for binding the two parts of a tackle fall with crossing turns. Riesenberg (1922) advises that, before a heavy boom topping lift's fall is shifted to another cleat, its hauling part be racked to the neighbouring part.
Where both parts take the load; Nares prescribes a throat seizing for that case.
Weakness
It is long and has several stages, and on heavy rope Knight says the parts must first be hove together with a device such as a Spanish windlass or rigger's screw; Wikipedia notes that because a loaded rope thins, seizings may slip even when properly made, so they are not recommended for critical heavy loads.