Loop
Yosemite bowline
Wraps the tail back through to reduce the bowline's tendency to loosen when unloaded.
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
How to tie it
- First tie a bowline. Make a small loop in the standing part: take the working end round to the right and OVER the standing part.
- Leave enough for the eye and a long tail: take the end down OVER the bar (ring), back UNDER it and up below the loop.
- Bring the end UP through the loop from underneath.
- Take the end around BEHIND (under) the standing part.
- Bring the end back DOWN through the loop: the bowline is done and the tail lies inside the eye.
- Yosemite finish: take the tail out round the FRONT of (OVER) the adjacent leg of the eye and back in BEHIND (UNDER) it.
- Feed the tail up along the standing part: UNDER the loop, UNDER its own way down, UNDER the crossing, and OVER the collar round the standing part; it comes out beside the standing part.
- First pull the standing part against the eye to set the bowline, then pull the tail. Leave a long tail.
The method was checked against: Wikipedia: Yosemite bowline, Knots 3D: Yosemite Bowline.
No sourced Turkish name yet.
- Where not to use it
- On its own as a life-safety tie-in without training.
- Weakness
- Tied wrong it can turn out worse than a plain bowline.
Similar and alternative knots
Sources and verification
- Wikipedia: Yosemite bowline
- Wikidata: Q835996
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.