
Loop
Cowboy bowline
A bowline variant with the tail on the outside of the loop.
How to tie it
- Make a small loop in the standing part: take the working end round to the right and cross it OVER the standing part.
- Leave enough for the eye: take the working end down, round, and back up below the loop.
- Bring the working end UP through the loop from underneath and out on the eye side (left) of the standing part, OVER the loop edge and the eye leg.
- Take the working end BEHIND (under) the standing part to the right: the opposite way to a standard bowline.
- Bring the working end back DOWN through the loop from above; the end finishes OUTSIDE the eye.
- Pull the standing part against the eye to set the knot.
The method was checked against: Knots 3D: Cowboy Bowline, Wikipedia: Cowboy bowline.
No sourced Turkish name yet.
- Where not to use it
- In climbing and rescue.
- Weakness
- More likely to open when the loop is pulled sideways.
Similar and alternative knots
Sources and verification
- Wikipedia: Cowboy bowline
- Wikidata: Q16952374
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.