Loop
Water bowline
A bowline variant that jams less and slips less in wet or icy rope.
How to tie it
- Make a small loop in the standing part: take the working end round to the right and cross it OVER the standing part (a half hitch).
- Start a second loop the same way, this time under the first: take the end down, round underneath to the right, and in UNDER the first loop.
- Bring the end out to the left UNDER the first loop and UNDER its own part: the two loops form a clove hitch in the standing part.
- Leave enough for the eye: take the end down, round, and back up below the place where the two loops overlap.
- Bring the end UP through both loops of the clove hitch from underneath.
- Take the end around BEHIND the standing part, that is, UNDER it.
- Bring the end back DOWN through both loops from above; it comes out inside the eye.
- Snug up the clove hitch, then pull the standing part against the eye to set the knot.
The method was checked against: Animated Knots: Water Bowline, Wikipedia: Water bowline.
No sourced Turkish name yet.
- Where not to use it
- In very thick rope.
- Weakness
- Needs one extra turn.
Similar and alternative knots
Sources and verification
- Wikipedia: Water bowline
- Wikidata: Q7973456
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.