Water bowline TR

Water bowline: How to tie it

The animation and practice area on this page need JavaScript. The steps are written out below.

Steps

  1. Make a small loop in the standing part: take the working end round to the right and cross it OVER the standing part (a half hitch).
  2. Start a second loop the same way, this time under the first: take the end down, round underneath to the right, and in UNDER the first loop.
  3. Bring the end out to the left UNDER the first loop and UNDER its own part: the two loops form a clove hitch in the standing part.
  4. Leave enough for the eye: take the end down, round, and back up below the place where the two loops overlap.
  5. Bring the end UP through both loops of the clove hitch from underneath.
  6. Take the end around BEHIND the standing part, that is, UNDER it.
  7. Bring the end back DOWN through both loops from above; it comes out inside the eye.
  8. Snug up the clove hitch, then pull the standing part against the eye to set the knot.

Back to the knot page