Friction hitch
Autoblock (French prusik)
Placed below the belay device when abseiling, it gives a backup lock if your hand slips.
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
How to tie it
- The loop is traced as one strand; the carabiner is shown as a bar. One leg of the lower end (B) is laid passing BEHIND the carabiner and going up.
- Wrap the loop round the main rope (the abseil ropes) four times from the bottom up: OVER (in front), UNDER (behind)… Leave room between the wraps for the second leg.
- Bring the upper end (A) down and clip it into the carabiner: in FRONT of it and back out BEHIND (under) it.
- Bring the second leg back down beside the same wraps: UNDER, OVER… The loop is wrapped double; the wraps must not cross each other.
- Clip the lower end (B) into the same carabiner too: down in FRONT of it. Both ends are in the carabiner; lock it to the leg loop.
- Weight the harness to test: it must hold and slide when pushed down by hand. Keep it clear of the descender.
The method was checked against: NetKnots: Autoblock Knot, Wikipedia: Klemheist knot.
No sourced Turkish name yet.
- Where not to use it
- As the main load-holding device.
- Weakness
- Too few wraps and it slips, too many and it sticks; it has to be tuned.
Similar and alternative knots
Sources and verification
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.