Autoblock (French prusik) TR

Autoblock (French prusik): How to tie it

The animation and practice area on this page need JavaScript. The steps are written out below.

Steps

  1. The loop is traced as one strand; the carabiner is shown as a bar. One leg of the lower end (B) is laid passing BEHIND the carabiner and going up.
  2. Wrap the loop round the main rope (the abseil ropes) four times from the bottom up: OVER (in front), UNDER (behind)… Leave room between the wraps for the second leg.
  3. Bring the upper end (A) down and clip it into the carabiner: in FRONT of it and back out BEHIND (under) it.
  4. Bring the second leg back down beside the same wraps: UNDER, OVER… The loop is wrapped double; the wraps must not cross each other.
  5. Clip the lower end (B) into the same carabiner too: down in FRONT of it. Both ends are in the carabiner; lock it to the leg loop.
  6. Weight the harness to test: it must hold and slide when pushed down by hand. Keep it clear of the descender.

Back to the knot page