Binding
Packer's knot
Ties parcels and meat joints tightly; can be cinched and locked.
How to tie it
- Take the twine round the parcel (shown as a bar): OVER (in front of) it and back BEHIND (under) it.
- Bring the working end down OVER (in front of) the standing part.
- Start a figure-eight: turn a loop with the end; close it at the top by going UNDER the standing part and OVER the end's own part. The standing part runs through this loop.
- Take the end round BEHIND (under) its own part and the standing part.
- Tuck the end into the loop (OVER its edge) and out UNDER its own part: the figure-eight is round the standing part; the tail and the standing part come out of the loop side by side.
- Pull the standing part to tighten the binding as much as you want; the figure-eight slides on it.
- Lock: make a small loop in the standing part (laid here) and drop it over the end: the end passes through it (OVER one side, UNDER the other).
- Tighten the loop on the end to lock the knot.
The method was checked against: Wikipedia: Packer's knot, Knots 3D: Packer's Knot.
Other English names: Packing Knot
No sourced Turkish name yet.
- Where not to use it
- For lifting.
- Weakness
- Can loosen before it is locked.
Similar and alternative knots
Sources and verification
- Wikipedia: Packer's knot
- Wikidata: Q7122943
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.