Bend
Beer knot
Makes a closed loop of flat webbing by threading the end inside the tape itself.
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
How to tie it
- A loose overhand knot is tied in the end of the first tape. Push the end of the second tape INTO the end of the first. The inner tape is drawn right beside the outer one; it passes everything the outer tape passes. First OVER the arc of the loop.
- Inside, the tape follows the knot backwards: UNDER the standing part.
- Along the lower edge of the loop, OVER the standing part.
- Along the arc of the loop, UNDER both ends.
- Leave the knot and push on inside the first tape's standing part (about 30 cm for 1-inch tape): OVER two strands, UNDER two. The second end stays hidden inside the tape.
- Slide the overhand onto the doubled section and tighten; set it with a heavy load. Check the visible end by eye and the hidden end by feel.
The method was checked against: Animated Knots: Beer Knot, Wikipedia: Beer knot.
No sourced Turkish name yet.
- Where not to use it
- In round rope.
- Weakness
- You cannot see from outside how long the hidden tail is.
Similar and alternative knots
Sources and verification
- Wikipedia: Beer knot
- Wikidata: Q4880031
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.