Beer knot: How to tie it
The animation and practice area on this page need JavaScript. The steps are written out below.
Steps
- A loose overhand knot is tied in the end of the first tape. Push the end of the second tape INTO the end of the first. The inner tape is drawn right beside the outer one; it passes everything the outer tape passes. First OVER the arc of the loop.
- Inside, the tape follows the knot backwards: UNDER the standing part.
- Along the lower edge of the loop, OVER the standing part.
- Along the arc of the loop, UNDER both ends.
- Leave the knot and push on inside the first tape's standing part (about 30 cm for 1-inch tape): OVER two strands, UNDER two. The second end stays hidden inside the tape.
- Slide the overhand onto the doubled section and tighten; set it with a heavy load. Check the visible end by eye and the hidden end by feel.