
Bend
Sheet bend
Turkish: Sancak bağı
Joins two ropes, especially two ropes of different thickness.
How to tie it
- The other rope lies as a bight: its standing part on the left, its short end on the right. Pass the working end UNDER the bottom of the bight and up through it.
- Bring the working end out OVER the right leg, then take it round BEHIND (under) both legs of the bight.
- Bring the end OVER the left leg, tuck it UNDER its own standing part and out OVER the right leg: the end is trapped between its own part and the bight.
- Pull all four parts to tighten. Both short ends finish on the same side of the knot.
The method was checked against: MEB MEGEP, Gemici Bağları modülü (2014), s. 5, NetKnots: Sheet Bend.
Turkish names, by who uses them
- Seafarers: Sancak bağı, Iskota bağı
- Sailors: Sancak bağı
- Fishers: Sancak düğümü, İngiliz düğümü
- Scouts: Sancak bağı
Other English names: weaver's knot
Main Turkish name from seafarers · Sahil Güvenlik, KÜRE (Deniz Harp Okulu), MEB, Denizcilik Müsteşarlığı, proje sahibi
Sources for the names
- Sahil Güvenlik Komutanlığı, "Gemici Bağları"
- KÜRE Ansiklopedisi, "Gemici Bağları" (MSÜ Deniz Harp Okulu "Denizcilik Köşesi", Sahil Güvenlik ve MEB'e dayanır)
- MEB MEGEP, Denizcilik: Gemici Bağları modülü (2014)
- T.C. Başbakanlık Denizcilik Müsteşarlığı, Denizcinin El Kitabı (2010)
- Proje sahibinin listesi
- Boğaziçi Üniversitesi Yelken, "Düğüm-1" ve "Düğüm-2" ders notları (2024)
- MEB MEGEP, Denizcilik: Ağ Bakımı ve Onarımı modülü (2016)
- Sakarya İzcileri, "İzci düğümleri: Gemici bağları"
- Where not to use it
- A single sheet bend where load comes and goes or the rope is shaken all the time; use the double sheet bend.
- Weakness
- Can loosen and slip when unloaded; the thicker rope should form the bight.
Similar and alternative knots
Sources and verification
- Wikipedia: Sheet bend
- Wikidata: Q1136533
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.