
Bend
Blood knot (barrel knot)
Turkish: Beden bağı
Joins two fishing lines of similar diameter with a slim, neat knot.
How to tie it
- Overlap the two lines from opposite directions. Take the first end OVER the other line and back UNDER it: the first wrap.
- Make two more wraps the same way, each OVER then UNDER the other line, working away from the middle.
- Make two more wraps: five in all.
- Bring the end back outside the wraps to the middle and pass it through the gap between the lines: in OVER its own line, out UNDER the other.
- Now repeat with the second end in the other direction: OVER the first line and back UNDER.
- Two more wraps: OVER, UNDER.
- Two more wraps: five on this side too.
- Bring the end back to the middle and pass it through the same gap in the OPPOSITE direction to the first end: in UNDER its own line, out OVER the other. The two ends stick out on opposite sides.
- Wet the knot, pull both standing lines slowly so the wraps close up in the middle, then trim the ends.
The method was checked against: Wikipedia: Blood knot, Animated Knots: Blood Knot.
Turkish names, by who uses them
- Fishers: Beden bağı
Other English names: Barrel knot
Main Turkish name from fishers · MEB olta modülü
Sources for the names
- Where not to use it
- In lines of very different diameter.
- Weakness
- Slips with too few turns; wet it before tightening.
Similar and alternative knots
Sources and verification
- Wikipedia: Blood knot
- Wikidata: Q514827
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.