
Hitch
Buntline hitch
Turkish label on Wikipedia (not verified): Buntline bağı
Ties a rope to a ring or eye so that it does not shake loose.
How to tie it
- Take the working end OVER the post (or ring), bring it back BEHIND (under) it and down beside the standing part.
- Make a full turn round the standing part: take the end OVER it, then back UNDER it.
- A little lower, take the end OVER the standing part again: this makes a band across the front.
- Bring the end up and through the hole beside the post: UNDER the standing part, between it and the leg.
- Bring the end down the front, OVER the turns.
- Tuck the end UNDER the band and out below.
- Push the knot up to the post and pull the standing part: a clove hitch forms on the standing part, its turns working towards the post.
The method was checked against: Animated Knots: Buntline Hitch, Wikipedia: Buntline hitch.
No sourced Turkish name yet.
- Where not to use it
- Where it must be untied often.
- Weakness
- Jams hard under load.
Similar and alternative knots
Sources and verification
- Wikipedia: Buntline hitch
- Wikidata: Q262227
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.