Hitch
Bale sling hitch
Makes a sling by passing a closed loop around the load and through itself.
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
How to tie it
- The sling is drawn as one rope whose two legs go up to the hook; the load is shown as a bar. Take one half of the sling down OVER (in front of) the load and back up UNDER (behind) it: the sling now passes under the load.
- Cross the sling OVER the other leg: this becomes the collar in front of the load.
- Take the other half round the opposite way: down UNDER (behind) the load and back up OVER (in front of) it.
- Pass the end of the sling UNDER the collar and up to the hook: both legs come out side by side under the collar and the sling grips the load like a cow hitch.
- Lift the hook slowly and check that the sling stays at the middle of the load. Nobody stands under the load.
The method was checked against: Wikipedia: Bale sling hitch, Knots 3D: Barrel Hitch.
No sourced Turkish name yet.
- Where not to use it
- On sharp-edged loads without protection.
- Weakness
- The load turns if the loop slides underneath it.
Similar and alternative knots
Sources and verification
- Wikipedia: Bale sling hitch
- Wikidata: Q10338487
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.