
Bend
Harness bend
An old bend for joining two ropes quickly.
How to tie it
- The first rope is held taut with its end crossed OVER its standing part to make a loop. Pass the second working end through the loop: in UNDER the right side, out OVER the first rope's end.
- Pinch the loop to keep the tension. Curve the end up and bring it down OVER the first rope's standing part, to the left.
- Half hitch: take the end round UNDER the standing part and up.
- Cross the end OVER its own descending part and bring it out UNDER the first rope's standing part into the middle eye.
- Snug the half hitch up against the first loop; both ends stay in the middle eye.
The method was checked against: NetKnots: Harness Bend, Wikipedia: Harness bend.
No sourced Turkish name yet.
- Where not to use it
- In life-safety work.
- Weakness
- Can loosen once the load is off.
Similar and alternative knots
Sources and verification
- Wikipedia: Harness bend
- Wikidata: Q5659733
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.