Shortening
Sheepshank
Turkish: Çürük bağı
Shortens a rope without cutting it; once used to take a worn section out of the load (MEB name: çürük bağı).
How to tie it
- Near the top make a small loop: pass the rope UNDER the standing part (an underhand loop, like a half hitch).
- Run the rope down and turn back up: the first two legs of the Z and the lower bight.
- Pass the upper bight through the loop: UNDER its lower edge, OVER its upper edge; the bight turns and comes back down the same way.
- Bring the third leg down beside the lower bight.
- With the third leg throw a loop round the lower bight: UNDER both its legs, back OVER them, and out under itself.
- Pull the ends apart to set the knot; remember it falls apart when the load comes off.
The method was checked against: Wikipedia: Sheepshank, Animated Knots: Sheepshank, MEB MEGEP, Gemici Bağları modülü (2014), s. 9.
Turkish names, by who uses them
- Seafarers: Çürük bağı, Margarita bağı
- Scouts: Margarita bağı
- General use: Margarita bağı
Main Turkish name from seafarers · Sahil Güvenlik, KÜRE (Deniz Harp Okulu), MEB
Sources for the names
- Sahil Güvenlik Komutanlığı, "Gemici Bağları"
- KÜRE Ansiklopedisi, "Gemici Bağları" (MSÜ Deniz Harp Okulu "Denizcilik Köşesi", Sahil Güvenlik ve MEB'e dayanır)
- MEB MEGEP, Denizcilik: Gemici Bağları modülü (2014)
- Proje sahibinin listesi
- Sakarya İzcileri, "İzci düğümleri: Gemici bağları"
- TÜBİTAK Bilim Çocuk, Temmuz 2019 eki "Düğümler"
- Where not to use it
- Where the load comes off and on; it falls apart.
- Weakness
- Falls apart easily when unloaded.
Similar and alternative knots
Sources and verification
- Wikipedia: Sheepshank
- Wikidata: Q2141619
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.