
Decorative
Diamond knot
Makes a round decorative knot in a lanyard or handle.
How to tie it
- Fold the cord in two. A loop is laid in the first leg. Pass the second leg's end UNDER this loop, then OVER the first leg's standing part.
- Take the end UNDER the first leg's end, OVER the loop, UNDER its own part and OVER the loop again: a carrick bend with the ends at diagonally opposite corners.
- Take the second leg's end OVER the first leg's standing part and round the side of the knot.
- Now do the same with the first leg's end: OVER the second leg's standing part and round the other side.
- Bring the end UNDER the knot and up through the centre.
- Bring the second leg's end UNDER the knot and up through the centre as well; both ends come out side by side.
- Set the loop to size and work the knot tight; the ends come out opposite their own standing parts.
The method was checked against: Wikipedia: Diamond knot, Knots 3D: Diamond Knot.
Other English names: knife lanyard knot
No sourced Turkish name yet.
- Where not to use it
- In load-bearing work.
- Weakness
- Tightening it takes effort.
Similar and alternative knots
Sources and verification
- Wikipedia: Diamond knot
- Wikidata: Q1208595
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.