Lashing
Diagonal lashing
Pulls together and binds two poles that cross at an angle and do not touch.
How to tie it
- The timber hitch is traced here from its tail. Draw the twists of the tail: they will end up wrapped round the returning leg of the noose.
- Draw the turn round the standing part; the end of the twists is tucked OVER the leg where it turns.
- Lead the returning leg through the twists (OVER, UNDER in turn) and round BEHIND (UNDER) both poles at the crossing.
- Bring the standing part back IN FRONT of (OVER) the poles and through the turn: the timber hitch is done. Pulling it draws the poles together.
- Take the rope up and OVER the front pole to the upper angle of the crossing.
- First set, on the diagonal opposite the timber hitch: down OVER everything in front, up UNDER everything behind.
- Make two more turns, each outside the one before: three turns on this diagonal.
- Go over the top and UNDER the back pole to the other diagonal. Second set: OVER everything in front, UNDER everything behind; it crosses the first set.
- Make two more turns of the second set, each outside the one before: three turns on this diagonal too.
- Two frapping turns BETWEEN the poles: UNDER the front pole and OVER the back one, pulling all the turns tight.
- Finishing clove hitch on the front pole: OVER the pole and back BEHIND (UNDER) it.
- Cross the end OVER its own part.
- Second turn the same way: OVER the pole and back UNDER it.
- Tuck the end UNDER the diagonal and lead it out.
- Tighten the lashing.
The method was checked against: Animated Knots: Diagonal Lashing, Wikipedia: Lashing (ropework).
No sourced Turkish name yet.
- Where not to use it
- For right-angle lashings.
- Weakness
- The poles slip if the frapping is incomplete.
Similar and alternative knots
Sources and verification
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.