Shear lashing TR

Lashing

Shear lashing

Binds two poles side by side so they can be opened into an A-frame or shear legs.

Medium No ABoK number Camping and scouting

How to tie it

  1. Starting clove hitch on the left spar, first turn: OVER the spar and back BEHIND (under) it.
  2. Cross the end OVER the standing part.
  3. Second turn the same way: OVER the spar and back UNDER it.
  4. Tuck the end UNDER the diagonal: the clove hitch is done.
  5. First wrap: OVER (in front of) both spars to the right, BEHIND (under) them back to the left.
  6. Make seven more wraps, each below the one before: eight tight wraps round both spars.
  7. First frapping turn between the spars: up OVER the wraps, down UNDER them.
  8. Second frapping turn outside the first.
  9. Finishing clove hitch on the right spar, first half hitch: OVER the spar and back BEHIND (under) it.
  10. Cross the end OVER its own part.
  11. Second half hitch: OVER the spar and back UNDER it.
  12. Tuck the end UNDER the diagonal and lead it out.
  13. Tighten the lashing, then spread the spars to form the shear legs.

The method was checked against: Animated Knots: Shear Lashing, Wikipedia: Lashing (ropework).

No sourced Turkish name yet.

Where not to use it
When the poles will not be spread.
Weakness
If the wraps are too tight the poles will not open.

Similar and alternative knots

Sources and verification

  • The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.