Hitch
Barrel hitch
Slings a barrel or bucket with rope so it can be lifted upright.
How to tie it
- Lay the rope on the ground. Bring the working end OVER the standing part to make a large, loose loop.
- Tuck the working end UNDER the standing part into the loop.
- Bring the working end out OVER the edge of the loop: a loose overhand knot lies on the ground.
- Where the rope crosses itself in the middle, take the upper strand, draw it towards you and lay it down again: a diagonal strand runs across the middle between two large loops.
- Stand the barrel on the diagonal strand in the middle. Lift the strands and loops up the sides; the knot wraps the upper part of the barrel.
- Join the two ends above the barrel with a bowline, snug the sling and lift slowly. Nobody stands under the load.
The method was checked against: Animated Knots: Barrel Hitch, Wikipedia: Barrel hitch.
No sourced Turkish name yet.
- Where not to use it
- With heavy, swinging loads.
- Weakness
- The load can tip over if it is unbalanced.
Similar and alternative knots
Sources and verification
- Wikipedia: Barrel hitch
- Wikidata: Q1397612
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.