Bend
Reever knot
Joins two ropes with a symmetric structure that does not jam under load.
How to tie it
- The other rope lies as a bight: standing part on the left, end on the right. Pass your end UNDER the bottom of the bight into it and out to the right OVER the other rope's end leg.
- Make your own bight above: take the end left OVER both legs of the other rope.
- Bring the end back right UNDER both legs of the other rope and turn it.
- Bring the end OVER the other rope's end leg into the bight and out UNDER its bottom: your end now lies beside your own standing part.
- Pull both standing parts and both ends together to tighten; each rope is gripped at two points.
The method was checked against: Wikipedia: Reever Knot, Wikipedia: Harness bend, Knots 3D: Reever Knot.
No sourced Turkish name yet.
- Where not to use it
- In life-safety work.
- Weakness
- Little known; you need to recognise its structure to check it.
Similar and alternative knots
Sources and verification
- Wikipedia: Reever Knot
- Wikidata: Q30641708
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.