Decorative · Stopper
Wall and crown knot
Turkish label on Wikipedia (not verified): Ceviz düğümü
A round end knot woven with the strands of a rope; used as a stopper and ornament.
How to tie it
- Unlay the three strands at the rope's end (seen from above; the rope runs away below).
- Wall: take the first strand round the standing part and UNDER the root of the next strand, leaving a bight.
- Take the second strand UNDER the end of the first and UNDER the root of the next.
- Take the third strand UNDER the end of the second and the root of the first, and up through the first strand's bight: a wall knot.
- Crown (the same way round as the wall): lay the first strand OVER the next one.
- Lay the second strand OVER the end of the first and OVER the next strand.
- Lay the third strand OVER the end of the second and the first, and tuck it UNDER the first strand's bight: the crown.
- Work the strands tight a little at a time, then trim the ends. (Following each strand round a second time gives a different knot: the manrope knot.)
The method was checked against: Animated Knots: Wall and Crown, A. Hyatt Verrill, Knots, Splices and Rope Work (1917), Bölüm VI, Şekil 110–116.
No sourced Turkish name yet.
- Where not to use it
- In braided rope (the strands cannot be separated).
- Weakness
- The strands have to be unlaid and counted.
Similar and alternative knots
Sources and verification
- Wikipedia: Wall and crown knot
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.