Hitch
Pipe hitch
Grips a pipe or pole with wraps so it can be pulled or lifted lengthwise.
How to tie it
- Wrap the end four times around the post: OVER it and back UNDER it each time, the turns lying side by side away from the standing part.
- First half hitch: take the end OVER the standing part, then around BEHIND (under) it and back.
- Bring the end down through the gap, OVER its own part.
- Second half hitch, same direction, below the first: end OVER the standing part, then back BEHIND (under) it.
- Bring the end down through the gap, OVER the part between the two hitches: a clove hitch on the standing part.
- Snug the turns, slide the half hitches up and tighten; load the pipe lengthwise, away from the turns.
The method was checked against: Wikipedia: Pipe hitch, ControlBooth Wiki: Pipe Hitch.
Other English names: Well-pipe hitch
No sourced Turkish name yet.
- Where not to use it
- When the load is at right angles to the pole.
- Weakness
- Slips unless the pull is away from the knot.
Similar and alternative knots
Sources and verification
- Wikipedia: Pipe hitch
- Wikidata: Q7197240
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.