Stopper
Heaving line knot
Adds weight to the end of a heaving line so it can be thrown farther and more accurately.
How to tie it
- Two bights lie side by side, pointing opposite ways. Pass the end through the top bight (in UNDER the middle leg, out OVER the standing part), then round UNDER both legs of that bight.
- Take the tail into the wraps: pass the end UNDER the tail to the right.
- Wrap all three legs together: OVER all three in front, UNDER all three behind.
- One more wrap, working down: OVER, then UNDER again.
- Pass the end through the bottom bight: OVER the tail, UNDER the middle leg.
- Pull the top loop up, then the standing part down, to tighten the wraps.
The method was checked against: NetKnots: Heaving Line Knot, Wikipedia: Heaving line knot.
Other English names: multiple overhand knot
No sourced Turkish name yet.
- Where not to use it
- As a stopper in the rope that carries the actual load.
- Weakness
- Needs many wraps; rushed wraps fall apart.
Similar and alternative knots
Sources and verification
- Wikipedia: Heaving line knot
- Wikidata: Q746893
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.