Bend
Butterfly bend
Joins two ropes with the structure of the alpine butterfly; unties after loading.
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
How to tie it
- The other rope lies as a loop, its end crossing OVER its standing part and pointing up. Make a loop in your rope and link it with the other loop: OVER it at the top, UNDER it at the bottom.
- Bring your end up OVER its own standing part: in both loops the end lies on top of the standing part.
- Curl the end round and tuck it through the middle of both loops: in UNDER your standing part and the edge of the other loop, out OVER the other loop and your own. It goes through the other loop before leaving its own.
- Do the same with the other end: in UNDER the top of its own loop and the other loop, turn in the middle and out OVER the other loop and the bottom of its own. Both ends come out below.
- Tighten each overhand knot, then pull the standing parts hard in opposite directions.
The method was checked against: NetKnots: Alpine Butterfly Bend, Wikipedia: Butterfly bend.
Other English names: Strait bend
No sourced Turkish name yet.
- Where not to use it
- Without knowing how to check it, because a wrong tie is hard to spot.
- Weakness
- A mistied version looks similar and is unsafe.
Similar and alternative knots
Sources and verification
- Wikipedia: Butterfly bend
- Wikidata: Q3533284
- The tying steps were played in the rope engine to produce the checking signature; the comparison with two independent sources is in docs/pilot-baglar.md.