Makes the end of a heavy rope or cable fast to a ring, an anchor ring or a sail's cringle: the end is led round the rope's standing part into a small ring and seized there.
Making a heavy rope or cable fast to a ring (an anchor ring or a sail's cringle) quickly and securely; in Jutsum, also making buntlines fast to the lower edge of a sail.
When
Unknown; the clinch is described in Lever's Sheet Anchor (the 1843 edition was consulted), and the name 'inside clinch' appears in Brady's The Kedge-Anchor (copyright 1847) and in Jutsum (1914).
Who devised it
Unknown.
Where the name comes from
Jutsum separates the clinches by where the end finishes: in the outside clinch the end is led over the top, on the side away from the bight. He also gives 'running clinch' as another name for the inside clinch.
Its story
A clinch is an old shipboard fastening: the end of a heavy rope is led round its own standing part and held there with seizings. Smyth's Sailor's Word-Book (1867) describes it as a half hitch whose end is seized back onto the rope's own part, and says it served mostly for bending hawsers in a hurry to the rings of kedges and small anchors, and for securing gun breechings to ring-bolts set in the vessel's side. In Lever's Sheet Anchor (the 1843 edition was consulted) the end goes through a cringle in the sail, comes back round the standing part to make a ring, and is held by two round seizings; the ring is always kept smaller than the cringle the rope runs through. Brady, describing how the cables are bent to the anchor, calls for an 'inside clinch' smaller than the anchor ring, with its seizings placed opposite one another. Jutsum (1914) gives the name 'running' or 'inside clinch' to the clinch an end makes upon its own standing part, and notes that it is commonly used for making buntlines fast along the sail's lower edge.