Joins the ends of two three-strand ropes with their own strands; it was once used to repair a shroud that had been shot through or carried away when there was no time to splice, and today it is mostly decorative.
Quickly joining a shroud that had been shot through or carried away, using the strands of both ends, when there was no time to splice.
When
Unknown; it is described in Darcy Lever's (1760?–1837) book and by Dana in 1841.
Who devised it
Unknown.
Where the name comes from
According to Wikipedia, the name shroud knot comes from the shrouds that support a ship's mast; the sources do not explain the word 'French'.
Its story
The French shroud knot is one of the shroud knots, which join the ends of two three-strand ropes by knotting their strands together instead of splicing them. These knots were used to repair, quickly and with little rope, a shroud that had been shot through or carried away; Wikipedia notes that because ships now mostly use steel wire, they are made more often as decoration. Darcy Lever's Sheet Anchor finds this form much snugger than the common shroud knot and just as secure; William Brady also calls it neater, and Verrill in 1917 says it is much tidier and better, though somewhat harder to tie. The sources, however, do not describe the same work under this name: in Lever, Dana and Brady the strands of one rope are laid back along their own rope and the strands of the other are walled around them; Hjalmar Öhrvall in 1916 wraps the strands of the two ropes around each other in turn and writes that his form strains the rope, so the common shroud knot should be preferred; and Verrill completes the work on one side and then repeats it on the other.