Works the Turk's head braid flat rather than round a pole, giving a round mat; fine cord makes a coaster or trivet, heavy rope a doormat or a cushion that guards the deck where a block strikes it.
HardABoK 1306Decoration and macraméSailing and boating
On board ship, cushioning the deck where a block strikes it and deadening the noise, and protecting a spot where a line rubs over an edge; also making coasters, trivets and doormats (Knots 3D).
When
Unknown; according to Knots 3D, Ashley found the name first in print in Darcy Lever's The Sheet Anchor (1808), and the flat form can be seen in Leonardo da Vinci's 15th-century drawings.
Who devised it
Unknown.
Where the name comes from
According to Wikipedia, the name Turk's head comes from the knot's likeness to a turban (though a turban is wound, not woven); Knots 3D also calls the flat form 'Turk's Head in the Flat' and its shipboard use a 'thump mat'.
Its story
According to Wikipedia, the Turk's head names a whole family of ornamental knots rather than a single one: woven passes of cord that close into a ring. Most are made round a cylinder, though they can also be laid out flat as a mat. Knots 3D writes that Ashley traced the first appearance of the name in print to Darcy Lever's The Sheet Anchor (1808), although the knot is much older: drawings by Leonardo da Vinci from the 15th century show Turk's heads in mat form, and traces of it appear in Roman mosaics. Laid on deck, the mat was known at sea as a thump mat: Knots 3D relates that Des Pawson, in Knot Craft and Rope Mats, describes fitting one over the eyebolt to which a deck block is shackled; whenever the rope through the block goes slack, the block lands on the mat instead of the planking, so there is less noise and less wear on the deck. Pawson says he first saw it used this way in Hervey Garrett Smith's The Marlinspike Sailor.
As a load-bearing knot, or where a ring is needed to go round a pole or handle; the ring form (Turk's head) is tied by a different method.
Weakness
If the slack is not taken up evenly round the whole circuit, the mat loses its shape; when the lead count and bight count are both divisible by the same number (e.g. 6 leads, 4 bights) one cord cannot complete it and a second is needed.