Makes a quick eye at the end of a wire rope without tucking any strands, by dividing the end into two three-strand sections and laying them back around each other; it is a temporary field expedient.
To put a quick, temporary eye in the end of a wire rope in the field.
When
Unknown; it appears by 1995 at the latest, in the U.S. Army's FM 5-125.
Who devised it
Unknown.
Where the name comes from
The word 'hasty' in the manual marks it as a quickly made field expedient; the source gives no other origin for the name.
Its story
The U.S. Army's 1995 rigging manual FM 5-125, in its section on eye splices in wire rope, gives the hasty eye as a field expedient that is occasionally needed. According to the manual's figure the wire's end is split into two three-strand sections, opened up for a length four times the eye's diameter; the sections are bent into a loop of the wanted size, twisted back around each other to close the eye, and seized. The manual says the eye is quick and simple but keeps only about 70 percent of the rope's strength, so it is not for lifting loads, and it can be made only in preformed wire rope.
For lifting: according to FM 5-125 the eye keeps only about 70 percent of the rope's strength and is not for lifting loads; it cannot be made in wire rope that is not preformed.
Weakness
It keeps only about 70 percent of the rope's strength (the same manual rates a good thimble eye splice at 70 to 90 percent); it is a temporary field expedient and no substitute for hands-on training in load work.