Forms a permanent eye at the end of six-strand wire rope by tucking its own strands back into the rope; on the first tuck three strands enter at the same place, and later tucks go over one and under one.
HardNo ABoK numberSailing and boatingLoads and everyday jobs
To form an eye at the end of six-strand wire rope aboard ship; according to the book, especially for handling guns and ordnance material.
When
Unknown; it is described by 1944 at the latest, in the U.S. Navy's Boatswain's Mate 2c training course (NAVPERS 10005).
Who devised it
Unknown.
Where the name comes from
According to Boatswain's Mate 2c, the name comes from the splice's use in handling guns and ordnance material.
Its story
The gun factory splice appears in the U.S. Navy's Boatswain's Mate 2c training course (1944 edition) as a wire-rope splice suited to work aboard ship. According to the book it takes its name from its use in handling guns and ordnance material. Following the book, it forms an eye at the end of six-strand wire rope: on the first tuck three strands go in at a single point, passing under three, two and one strands in turn, and the other three each go over a strand and then under that same strand. On the next two full tucks each strand goes over one and under one; the book adds that the strands may be reduced on the second and third tucks to give a tapered splice for appearance.
Where an eye is needed in a hurry; the same book says wire splicing takes considerable time and skill, and that in a hurry an eye is almost always made with wire rope clips.
Weakness
The book gives no strength figure, so the source does not tell how much it holds in lifting work; the job needs a rigger's screw, marline spikes, a hammer and a small tackle, and the book calls wire splicing 'definitely not child's play'.