Joins two ropes, even of different thickness, like a sheet bend; the extra tuck lays the short end inside the knot so that it is less likely to snag when the rope is hauled over an edge or obstacle.
MediumABoK 1436Loads and everyday jobsCamping and scoutingSailing and boating
Pass the working end of the second rope through the bight, take it around both legs of the bight and UNDER its own standing part; this is a sheet bend, so do not tighten it yet.
Now lead the working end back across its own standing part, passing OVER it.
Pass the working end through the loop that the sheet bend makes around the bight, so that it lies alongside the two legs of the bight and points the same way.
Pull all the ends to tighten; if the rope will be hauled over an obstacle, lay the short ends so that they trail behind the pull.
Joining two ropes that will be dragged or hauled over an edge or obstacle so that their short ends do not snag.
When
Unknown; The Ashley Book of Knots (1944) lists it as #1436.
Who devised it
Unknown; according to Knots 3D, Ashley does not name an inventor.
Where the name comes from
It comes from tucking the working end of a sheet bend once more; Knots 3D notes that this tuck forms a figure eight, which is why the knot is also called the 'Figure Eight Sheet Bend' or 'Figure Eight Becket Bend'.
Its story
Ashley gives this bend the number 1436 in his book The Ashley Book of Knots (1944); according to Knots 3D, he records no date or inventor for it. Geoffrey Budworth knows the same knot as the 'One-Way Sheet Bend', and Frank Rosenow, a sailor and writer, drew it under the name 'Tucked Sheet Bend' in Seagoing Knots (1990). An extra tuck added to a sheet bend lays the short end inside the knot; NetKnots writes that this makes the ends less likely to snag when ropes are hauled over an edge or obstacle, and Knots 3D recommends the bend for ropes that will be dragged over rough ground or through rocky gaps, or towed through water.
Where the rope will be dragged or hauled in both directions; the anti-snag benefit only comes when the short ends are laid so that they trail behind the pull.
Weakness
Its ends are laid for one direction of pull, and the benefit is lost when it is dragged the other way; it takes one more step than a plain sheet bend.