Covers an anchor ring, first parcelled with tarred canvas, with short lengths of rope laid side by side and seized in place, so that a hemp anchor cable does not chafe on the ring.
Keeping a hemp anchor cable or hawser from chafing on the ring of the anchor (Smyth).
When
Unknown; the earliest of the sources consulted is Lever's Sheet Anchor (first edition 1808).
Who devised it
Unknown.
Where the name comes from
Smyth gives the word as 'puddening, or pudding' and uses the same name for the thick pad round a mast and for a fender on a boat's stem; Ashley says the name 'pudding' for such a pad comes from 'bagpudding'.
Its story
In the days of hemp anchor cables, the ring of an anchor was covered so that the cable bent to it would not chafe and wear; Smyth's nautical dictionary of 1867 also uses the name pudding for this covering round an anchor ring. Lever's Sheet Anchor (first edition 1808) describes the work like this: the ring is first parcelled with tarred canvas, then lengths of rope made up again from old yarns are laid over it, hove taut with a heaver and seized at intervals. Brady's The Kedge-Anchor (1847) describes the same job with four seizings, and Ashley, following Lever, says the covering is made with five lengths of rope. Luce notes in 1866 that it was done where hemp cables were in use.
On anchors that do not take a hemp cable, for instance ones shackled straight to chain; Luce says the covering was put on where hemp cables were in service.
Weakness
It is a long job: the lengths are heaved round with a heaver and seized at intervals, and Lever says it is this heaving that makes them lie snug and level.