Stretch a light line horizontally where the top edge of the mat will be and make both its ends fast.
Hang strands made of a few hand-twisted yarns (foxes or nettles) over this line by their middles, side by side, across the full width of the mat.
Twist the two halves of the left-hand strand once round each other and pass one half to the back, or to your partner if two are working.
Twist the next strand once in the same way and send one half back, then twist its front half together with the half of the previous strand that went back; carry on like this so the work runs diagonally down and to the right.
Once the mat is wide enough, add no more strands; bring the outer right strand in from time to time to form a neat right edge, and keep working down to the length you want.
Stretch a second line along the bottom, open each strand's two halves around it, half-hitch the strand to the line and work the end back up through the twists with a marlinespike.
For a softer face, push short pieces of old rope strand a few inches long through the gaps and open out their ends (thrumming).
Keeping yards, rigging and ropes from wearing through where they rub against each other.
When
Unknown; the oldest source we opened is Darcy Lever's book (our copy is the second edition of 1819).
Who devised it
Unknown.
Where the name comes from
The sources do not explain the word 'paunch'; Lever calls it a 'wrought mat' (a mat worked by hand) and Brady a 'panch or wrought mat'.
Its story
The paunch mat is a thick, stiff mat that sailing ships lashed over the chafing points of their yards and rigging; Smyth's sailor's dictionary of 1867 counts it as the largest and strongest kind of mat. Darcy Lever's The Young Sea Officer's Sheet Anchor (our copy is the second edition, dedicated in 1819) describes the same work as a 'wrought mat' made by two people, Brady's Kedge-Anchor calls it a 'panch or wrought mat', and Alston's Seamanship (1871) and the Admiralty manual reprinted in 1915 call it a paunch mat. Hasluck adds in 1907 that, worked in untarred stuff, such mats make door-mats that hardly ever wear out. Smyth also remarks that, wherever it could be done, rounding had by then replaced mats, since it was tidier and kept less water.
Where it should not hold water; Smyth notes that wherever it could be done, rounding had taken the place of mats because it is neater and holds less water.
Weakness
Every strand has to be twisted and worked in by hand, usually by two people, and Hasluck admits the first rows are a little awkward.