Joins lead-core line to a leader: the leader goes into the sheath after the lead has been cut out, the sheath grips it and an overhand knot tied in the sheath locks the join; NetKnots advises one knot for a monofilament leader and two for braid.
To join lead-core line to a leader without a bulky knot, so that the join runs easily through the rod guides.
When
Unknown; NetKnots introduced it on its blog in 2013, and the same year an angler on a Lake Ontario forum wrote that he had used it for at least ten years.
Who devised it
Unknown.
Where the name comes from
Unknown; NetKnots mentions that some anglers have nicknamed it the 'Bruce Willis' knot.
Its story
The Willis knot is a connection for joining lead-core line to a leader: the braided sheath is slid back 4–6 inches (10–15 cm) and the lead wire inside is cut at that point, the leader is pushed into the empty sheath until it meets the lead, and the sheath grips it the way a Chinese finger trap does, while an overhand knot tied in the sheath locks the join. In January 2013 NetKnots introduced it on its blog as an easy-to-tie, compact yet very strong connection that runs smoothly through the rod guides, and mentioned that some anglers have nicknamed it the 'Bruce Willis' knot. The same year, on a Lake Ontario anglers' forum, one angler wrote that he had used it on his lead-core lines for at least ten years without a slip or failure, while another said he used an Albright instead because he could never get the leader into the sheath.
On any line without a hollow sheath from which a lead core can be removed; it only works with lead-core line.
Weakness
Feeding the leader into the empty sheath can be fiddly: one angler on a Lake Ontario forum says he uses an Albright because he cannot manage it; NetKnots says to pull hard on the leader afterwards to check that it does not slip.