Lays two poles side by side and binds them with tight half knots tied alternately in front and behind, making a single long, rigid pole such as a flagpole.
Where the two poles overlap, pass the rope behind them and bring both ends round to the front.
In front, tie the two ends together with a half knot (an overhand knot) and pull it as tight as you can.
Carry the ends round to the back of the poles and tie a second half knot there, right beside the first.
Go on tying half knots, front and back in turn, pulling each one hard and pressing it against the previous one.
When you have six to ten half knots, close the lashing with a reef (square) knot.
According to Scout Pioneering, to lengthen a pole you need two such lashings, one near each end of the overlap, and no frapping turns between the poles.
Overlapping two poles to make a single long, rigid pole such as a flagpole.
When
Unknown; the sources give no date of origin. The instructions Scout Pioneering quotes come from Peschke's Pioneering merit badge pamphlet, 1993 edition.
Who devised it
Unknown.
Where the name comes from
The sources do not explain the name; Scout Pioneering notes that the rope follows the same pattern as the West Country whipping.
Its story
It is a pole lashing from Scout pioneering, the craft of building structures out of spars and rope. The instructions and drawings Scout Pioneering gives for it come from text Adolph E. Peschke wrote for the Pioneering merit badge pamphlet, 1993 edition (1998 printing): there the rope is said to follow the same pattern as a West Country whipping, the one change being that here it goes around two spars, and Peschke judges the method very strong and effective. A note on the site argues that the proper name is West Country round lashing: as in every round lashing there are no frapping turns, and the two parallel poles end up joined rigidly, whereas shear lashings exist to give a hinge that opens when shear legs are set up. Knots 3D recommends it for making one tall pole, a flagpole for instance, out of shorter spars.
On shear legs that must be spread apart (an A-frame); this lashing has no frapping turns, so a shear lashing with frapping turns is used there.
Weakness
With six to ten tight half knots it is very strong, but according to Scout Pioneering it can be a little hard to untie; a single lashing will not hold an extended pole, so the overlap needs one near each of its ends.