Joins two lines, especially slippery synthetic cord and shock cord where a sheet bend slips, with a structure in which each line is gripped at two points inside the knot and which does not loosen under intermittent loading.
Joining slippery synthetic line and shock cord, on which bends such as the sheet bend slip, with a structure in which each line is gripped at two points inside the knot and which does not work loose under intermittent loading.
When
1989, when Harry Asher presented it as a new knot in The Alternative Knot Book. The same structure, loaded on different ends, had already appeared in print in 1928 as the Reever knot.
Who devised it
Harry Asher.
Where the name comes from
Unknown; the sources do not explain where the name comes from.
Its story
In 1989 Harry Asher labelled the Vice Versa bend a 'new' knot in The Alternative Knot Book; he offered it together with the Simple Simon Over and the Simple Simon Under as three steps in one line of development that took its ideas from the sheet bend. Roger E. Miles analysed 60 symmetric bends in Symmetric Bends (1995), listing this one as no. 19 and crediting Asher, and Geoffrey Budworth gave it a place in The Book of Practical Knots (2000). Writing in Knotting Matters no. 85 in 2004, Dick Clements showed that its structure is the same as that of the Reever knot, which C. E. I. Wright and J. E. Magowan had put forward in a 1928 article in the Alpine Journal; the two knots differ only in which ends carry the load as standing parts. Knots 3D and ITS Tactical both single it out for joining shock cord and slippery synthetic line.
In thin cord that must be untied easily after a heavy load; where a fully symmetric bend is wanted, Clements recommends the Reever form of the same structure.
Weakness
Knots 3D warns that once it has held a heavy load it is hard to undo, above all in thin cord; it has the same structure as the Reever knot and differs from it only in which ends take the load, and Wikipedia notes that this form is not strictly symmetric.