Joins two strips of leather, cords or twines of equal size securely with very little material; the ends come out side by side, pointing the same way (Knots 3D).
To join two strips of leather, cords or twines of equal size securely and with little material, with the ends coming out side by side.
When
Unknown; Ashley gives it as #1421 in The Ashley Book of Knots (1944).
Who devised it
Unknown; Clifford W. Ashley recorded it in his book as #1421.
Where the name comes from
According to Wikipedia, the harness bend probably owes its name to its use in fastening a saddle on a horse's back.
Its story
In The Ashley Book of Knots, published in 1944, Clifford W. Ashley gives two forms of the double harness bend under separate numbers: #1420, with the ends leaving in opposite directions, and #1421, with the ends lying side by side and pointing the same way. Knots 3D rates both forms as sound and secure and notes that Ashley favoured the parallel-ended one; it also reports that Ashley called the knot hard to untie, a point others dispute. Wikipedia describes this form as an unfinished reever knot: if each end is also tucked through the other rope's half hitch, the result is a reever. According to Wikipedia, the harness bend probably owes its name to its use in fastening a saddle on a horse's back.
For life-safety joins and for joining lines of different thickness; the source describes it for material of equal size, and Knots 3D advises checking with an instructor wherever a failure could cause harm.
Weakness
The sources disagree about untying: Knots 3D reports that Ashley found it hard to untie while others say it is not; Wikipedia describes it as an unfinished reever knot.