A separate length of rope that grips a mooring line tensioned by the winch and holds it for a short time, until the line has been made fast on the bitts.
Holding a mooring line tensioned by the winch so that it cannot run back, until it has been taken off the winch and made fast on the bitts.
When
Unknown; no date appears in the sources.
Who devised it
Unknown.
Where the name comes from
According to Animated Knots, on deck it is usually just called the 'stopper'; publications use names such as mooring line stopper, rat-tailed stopper and rat tail stopper. MEB calls the job 'halat bosası'. The sources do not say where 'rat-tail' comes from.
Its story
When a large ship moors alongside, the mooring line is first tensioned with the winch; to free the winch for the other lines, the line then has to be moved onto the bitts. During this short transfer the load of the taut line is held by a separate rope made fast at the foot of the bitts: the stopper (Animated Knots, MEB). The MEB module says the stopper's tail should not be tied off: a knot there jams as the load comes on and is then hard to undo, so the tail is left long and someone at the mooring station holds it and pulls on it by hand. Animated Knots also photographs a double-ended form for the same job and likens it closely to the cross-lashed strap (#1755) described by Ashley.
For holding a load for long or permanently, or wherever the tail would have to be tied off; a stopper is used only during the transfer, with its tail held by hand.
Weakness
It holds the load only by friction and by the tail held in a hand; a parting or slipping line can snap back, and a tail left too short can trap the hand against the rope.