Lashes two or more driven stakes together with turns running from the head of each to the foot of the next, twisted tight with a stick, to make a ground anchor for a guy line or rigging.
MediumNo ABoK numberLoads and everyday jobsCamping and scouting
Drive the pickets one behind another in the line of pull, their heads leaning away from the pull (FM 5-125 says at least 15° from vertical, the Scout source about 20°).
Put several turns between the head of the front picket and the foot of the one behind: FM 5-125 begins by clove-hitching the rope to the head of the front picket, takes four to six turns and ties the end off to the rear picket, again with a clove hitch, a little above the turns; the Scout source passes an endless loop, its ends joined with a sheet bend, round at least twice.
Push a stick between the turns and twist it to wind the turns up tight.
Drive or press the stick's end into the ground so the turns cannot unwind.
If there is a third picket, make the same lashing from the head of the second picket to the foot of the third.
Fasten the line that carries the load to the front picket; the Scout source wants it to bear on the stake as close to the ground as possible.
Fastening a guy line or rigging to the ground where there is no tree or rock to tie to, and spreading a load too great for one stake over several.
When
Unknown; no date appears in the sources.
Who devised it
Unknown; it is described in the U.S. Army rigging manual and in Scout pioneering material.
Where the name comes from
In FM 5-125 'picket' means a stake driven into the ground and 'holdfast' an anchor; names such as '1-1-1' give the number of pickets in each row.
Its story
A picket holdfast is a ground anchor made by driving stakes (pickets) into the earth and lashing them to one another. The U.S. Army rigging manual FM 5-125 (1995) explains that a single picket can serve as an anchor, but that its holding power depends on the picket's diameter and material, the type of soil, the depth and angle at which it is driven and the angle of the guy line to the ground; several pickets driven one behind another and lashed together share the load and are much stronger than one. The arrangements are named by the number of pickets in each row: '1-1', '1-1-1', '3-2-1'. Scouts in the United States use the same arrangement for their pioneering projects: the Scout Pioneering site presents the 3-2-1 layout as the simplest way to build a very strong anchor, allows 2-1-1, 1-1-1 or 1-1 where the strain is lighter, and says tent pegs must never be used as anchor stakes, being neither long nor strong enough.
In ground where the stakes cannot be driven firm enough not to wobble, and with tent pegs as the anchor stakes; for rigging that carries people or lifts loads, this information is no substitute for hands-on training.
Weakness
Its holding power depends on the soil, the thickness of the stakes and the depth and angle at which they are driven, and drops in wet ground; the farther a picket is from the front one, the more unevenly the load reaches it.