Permanently stops a rope's end from fraying: twine is wound round the rope and the turns are stitched into the grooves between the strands with a needle.
Thread waxed whipping twine on a sail needle and, where the whipping is to start, pass the needle UNDER a strand to anchor the twine's end.
With the long part of the twine, wind tight turns side by side around the rope, pulling each one hard.
When the whipping is wide enough, pass the needle UNDER a strand so the twine comes out in the groove between two strands.
Lay the twine along that groove OVER the turns to the far edge of the whipping, and there pass the needle UNDER a strand again so it comes out in the next groove.
Work back and forth from edge to edge like this until every groove has a frapping turn lying over the whipping.
Secure the end by stitching it between the strands a few times, then cut it short.
To stop a rope's end unravelling for longer than a hand-wound whipping can; the stitched frapping turns make the whipping harder to slide off.
When
Unknown; no date appears in the sources. Jutsum described it in 1914 and Öhrvall in 1916.
Who devised it
Unknown.
Where the name comes from
The palm is the sailmaker's leather hand guard with an iron plate for pushing the needle (Dana, 1847); this whipping is sewn with palm and needle. In Swedish it is called 'krysstagling' or 'sydd tagling' (Öhrvall).
Its story
Whipping sewn with a sailmaker's needle and palm is counted among the most durable ways to keep a rope's end from fraying. In 1914 Jutsum presented it as longer-lasting than an ordinary whipping wound on by hand, and, as Wikipedia quotes him, Ashley rated this 'palm-and-needle whipping, or sailmaker's whipping' the best of all whippings. The 'palm' in the name is the leather hand guard with an iron plate that pushes the needle through canvas (Dana, 1847). Writing in Swedish in 1916, Öhrvall described the same whipping as 'krysstagling' or 'sydd tagling', that is cross or sewn whipping, worked with a sail needle.