Makes a permanent eye in the end of high-modulus hollow single-braid rope such as Dyneema or Spectra by burying a long tail in the rope's core; because it does not bend the fibres it keeps nearly all of the rope's strength.
HardNo ABoK numberSailing and boatingLoads and everyday jobs
Working back from the end of the rope, mark how long the buried tail, the eye and the bury section will be.
Taper the tail: mark six strands in three alternate pairs, draw each one out and trim it off flush.
Push the splicing fid into the hollow centre at the eye mark, slide it along inside and let it emerge at the far end of the bury section.
Seat the tapered tail in the fid and draw both through the inside of the rope together.
Set the eye to the size you want, take out the fid and stroke the rope from the eye towards the tail until the tail disappears inside.
Stitch through the buried section from end to end with a needle and twine so the tail cannot shift; the stitching adds no strength and only holds the tail in place.
Making a permanent eye in slippery, high-modulus braided ropes, which lose much of their strength in knots and kinks, without bending or crushing the fibres, so that almost all of the strength is kept.
When
Unknown; no date appears in the sources.
Who devised it
Unknown.
Where the name comes from
The name describes the long tail buried inside the rope, which Animated Knots says is where the splice gets its strength; some authors call it an unlocked Brummel.
Its story
The long bury splice is an unlocked eye splice made by burying a long length of the end of a hollow single-braid rope inside its own core. Animated Knots notes that some authors call it an unlocked Brummel, whereas it uses 'Brummel' only for the version with a lock. The method is meant above all for loosely braided ropes of high-modulus fibres such as Dyneema, Spectra, Vectran or aramid: according to Animated Knots a knot or kink can cut the strength of these ropes to as little as 30 percent, while a well-made bury keeps 90–100 percent; Brion Toss and Starzinger both advise burying a tail 72 rope diameters long. A training document on the Oregon OSHA website shows the same splice in 12-strand braided rope step by step in photographs, and stresses that the stitching that holds the tail adds no strength and only keeps the tail from being pulled out by hand.
In three-strand laid rope and in rope with a separate cover (double braid); the method is for hollow single-braid rope.
Weakness
It has no lock: when the rope is slack the tail can shift or pull right out, so stitching is recommended; a short tail or an abrupt taper makes the splice a weak point.