Lifting heavy, smooth cylinders such as scaffold poles or boat masts with a lengthwise pull, or pulling them out of the ground; holding on slippery surfaces where the timber hitch and killick hitch may not hold, and coming off easily afterwards.
When
Unknown; Knots 3D says hitches built on this pattern are already found in Charles Warner's 1992 book.
Who devised it
Unknown.
Where the name comes from
From its job, lifting; according to Knots 3D, later knotting manuals give the hitch under this name.
Its story
According to Knots 3D, hitches wound in this way already appear in 'A Fresh Approach to Knotting and Ropework', the book Charles Warner published in 1992, while the name lifting hitch comes from later knotting books. The hitch is used to raise heavy, smooth cylinders such as scaffold poles or boat masts with a pull along their length. Because its hold comes from the friction of six to eight tight turns rather than from a crossing or two, it stays put even on varnished timber or on metal spars; that is why those books suggest it in place of the timber hitch or killick hitch for hoisting a spar. Once the job is done it is easy to take off.
Where the pull is perpendicular to the object or downward (Knots 3D requires the pull to run upward along it), and for lifting loads without hands-on training.
Weakness
Its grip comes from the friction of the turns (the source considers six to eight enough), and the source only describes a pull running upward along the object; for lifting loads none of this replaces hands-on training.