Shortens a sling that is placed round a load like a bale sling but is too long for it: a second loop is formed with the looped end, a reef knot is begun where the parts cross, and the loops are drawn up; it also helps balance a load lifted with two slings.
Shortening a bale sling that is too long for its load, and balancing a load lifted with two slings.
When
By 1921 at the latest: described in Dana and Pearl's engineering bulletin of the State College of Washington.
Who devised it
Unknown.
Where the name comes from
Unknown; the source does not explain the name.
Its story
The hamburger hitch is one of the knots described among rope and tackle work in a December 1921 engineering bulletin of the State College of Washington (H. J. Dana and W. A. Pearl, The Use of Ropes and Tackle). The bulletin suggests it when a bale sling turns out longer than the load needs, and adds that it can even out a load hung from two slings. While there is no strain on it, the knot can be shifted up or down the rope to adjust it; once the strain comes on, the bulletin says, it stays put. The source does not say where the name comes from.
For lifts that carry people or where a falling load would put lives at risk, and when the sling is already the right length for the load.
Weakness
It rests on a single 1921 bulletin and its strength under load is not tested in any other source; while slack the knot slides along the rope, so it must be set and tightened before the load comes on; for lifting it is no substitute for hands-on training.