Cut a short piece of cord separate from the main line (NetKnots says about 15 cm, Joe Shead about 30 cm; Dacron, braid or mono about as thick as the line will do).
Lay the cord along the main line where the float should stop and bend its end back to form an open loop beside the line.
Pinch the cord with your fingers at the point where it lies across itself and the main line.
Take turns with the working end round the main line and the laid part of the cord, passing the end through the loop on every turn (NetKnots says 2–3 turns, Joe Shead 6).
Draw both ends of the cord apart to snug the knot down, then trim them.
Below the knot, slip a bead (Joe Shead's advice) and then the float onto the main line; set the depth by moving the knot along the line.
Stopping a sliding float at the chosen depth on the line, with a knot that can still pass through the rod guides when casting.
When
Unknown; no date appears in the sources.
Who devised it
Unknown.
Where the name comes from
The English name comes from its job of stopping the bobber (float).
Its story
Say you are fishing a slip float from the shore of a lake and want the bait to hang deep, near the bottom. You tie a small knot onto the main line with a separate piece of cord. When you cast, the knot runs through the rod guides and onto the reel; once the bait lands and goes down, the float rides up the line and stops against the knot. To change the depth, you simply slide the knot along the line with your fingers.