Gives the line a strong, slim doubled section with a loop, built from a long braid; anglers use it in place of the Bimini twist to join a leader loop to loop.
Double the line to the length you need to make a long loop, leaving a long working end.
Wrap the working end around the standing part and bring it back between the two legs of the loop, then pinch this starting point tight; there are now three strands hanging down: the two legs of the loop and the working end.
Keeping the standing part taut, plait these three strands together in a tight three-strand braid, pinching the braid between thumb and forefinger as you go.
Carry on until the braid is long enough for the line: 2.5–4 cm for light line, up to about 20 cm for the heaviest.
Form a bight in the working end and continue the braid with this doubled working end for about three more plaits.
Feed the main loop through the bight you made in the working end.
Wet the knot, pull smoothly on the working end to draw the bight snug against the end of the braid, and trim the working end.
To give the last part of the line a strong, slim doubled section that joins a leader loop to loop; people who favour it say it is simpler to learn and faster to tie than the Bimini twist.
When
Unknown; no date appears in the sources.
Who devised it
Unknown.
Its story
Say you are rigging for a big fish offshore and want a long doubled section at the end of the line that will join a leader loop to loop. Instead of a Bimini twist you double the line and braid the two legs of the loop and the working end together in a tight three-strand plait. Because the braid is long, the load reaches the knot gradually rather than all at once, and the finished knot stays slim enough to pass through the rod guides without catching.
Where a short loop will do, or where you cannot keep the line taut and braid it tightly; the knot only works well with a long, tight braid.
Weakness
The full-strength claim comes from ideal laboratory conditions, and Animated Knots says it found no careful test report for this knot; sudden jerks create frictional heat and can make it fail at a lower load.