Tensions a load or a lashing like a block and tackle by making two loops in the rope and running the end back and forth between them; unlike the trucker's hitch it locks itself under tension.
MediumNo ABoK numberLoads and everyday jobsCamping and scouting
Make a fixed loop at the very end of the rope, then a second one farther along, placed so the gap between them is a little less than the span you want to tie down (an overhand loop will do, though a butterfly loop is better because it does not jam under load and unties easily).
Pass the working end, the rope left beyond the second loop, through the loop at the end.
Bring the working end back and pass it through the loop partway along the rope.
Keep running the working end back and forth between the two loops until each loop holds two or three strands.
Pull on the working end to take up the slack and tension the rig; when you let go, the tension holds by itself.
Tensioning a rope and holding the tension without a block and tackle; it works like a trucker's hitch but locks itself under tension.
When
Unknown; no date appears in the sources. On the IGKT forum in 2012 members wrote that they could not find it in Ashley's book.
Who devised it
Unknown.
Its story
The versatackle is an arrangement for tensioning a rope in the manner of a block and tackle, with no extra hardware: two loops are made in the rope and the end runs back and forth between them a few times. Wikipedia credits the name to Geoffrey Budworth's The Complete Guide to Knots and Knot Tying. On the IGKT forum in 2012, members wrote that they could not find it in Ashley's book, the nearest thing being the trucker's hitch arrangement; one member wrote that versatackles set 120 degrees apart around a post can be used to bring it plumb before the concrete is poured. The scouting resource InsaneScouter describes it in its pioneering section among the lashings, suggests it for binding, clamping or pulling, and favours butterfly loops at both points.
Where the rope must be spared wear: as the end is drawn through the loops, the squeeze, rubbing and heat can wear the loops out faster.
Weakness
Although it self-locks, a flapping free end can let the tension slacken, so some IGKT forum members finish it with a tie-off; the sources give no strength figures.