Makes an improvised rappel seat with a waist loop and leg loops from a single rope when no harness is available; the U.S. Army manual FM 3-97.61 teaches it as the 'rappel seat'.
MediumNo ABoK numberClimbingSearch and rescue
Life safety: This knot is used in climbing, rescue or tree work. This app does not replace hands-on training; for life-safety work, practise under an instructor.
Take a sling rope (FM 3-97.61 says it usually needs to be at least 14 feet, about 4.3 m), find its centre and make a bight there.
Choose your brake hand, then put the bight against the hip on the other side.
Reach round behind you for a single strand, carry it round your waist to the front, and knot it onto the other strand with two overhands to close a loop about your waist.
Take both ends down between your legs to the back without letting them cross.
At the back, bring the ends up UNDER the waist loop (FM 3-97.61 has them centred on the back pocket flaps) and pull to snug the seat.
Pass each end from back to front through the leg loop on its side so that it forms a half hitch on each hip.
Lead the longer end across your front to the non-brake hip, join both ends with a square (reef) knot, secure that knot with an overhand on each side, and push the leftover rope into the pocket under it.
Rigging a seat for rappelling from a single rope when no harness is available; Knots 3D sees it as suited to emergencies and to people who would rather not buy a harness.
When
Unknown; the U.S. Army manual FM 3-97.61 (2002) teaches it as the 'rappel seat'.
Who devised it
Unknown.
Where the name comes from
The sources do not explain the name 'Swiss seat'; FM 3-97.61 calls it the 'rappel seat', and Knots 3D gives both names.
Its story
The Swiss seat is a rappel seat made from a single rope when no harness is at hand. The U.S. Army mountaineering manual FM 3-97.61 (2002) teaches it as the 'rappel seat', tied in seven steps, usually from a sling rope of at least 14 feet, and checked against five points. Knots 3D says it can be made from rope or webbing, in left- or right-handed forms, and that the version it shows is the one taught in the U.S. Army and Marine Corps. The same source sketches the wider history of harnesses: it credits Jeanne Immink, a Dutch climber of the late 1800s, with the first climbing harness, and says sit harnesses were developed by Yosemite climbers in the 1960s.
On any descent where a mistake could cause injury or death and no instructor has checked the tie; Knots 3D asks for the method to be verified with a skilled instructor. This page does not replace hands-on training.
Weakness
It is an improvised seat and can be trusted only when every checkpoint holds: two overhand knots in front, no crossed ropes between the legs, a half hitch on each hip, a square knot backed up with overhands, and a tail of at least 4 inches (about 10 cm), per FM 3-97.61.