Bring the working end back OVER the standing part, forming a loop between the ring and the standing part.
Without pulling the end right through, double the working end into a bight, lead it UNDER the standing part and tuck it through that loop, leaving the end outside.
Haul on the standing part to tighten the bight; the hitch holds while the standing part is under strain.
To release it, give the free end a sharp pull: the bight comes out of the loop and the hitch falls open.
To make a boat's painter fast to a pier ring, or a small boat's sheet fast, for a while and be able to let it go with a single pull.
When
Unknown; no date appears in the sources. Hasluck described it in 1907.
Who devised it
Unknown.
Where the name comes from
Hasluck also calls the version tied to a ring the 'slippery ring knot'.
Its story
The slippery hitch, found in knot books of the early 1900s, makes a rope fast to a ring or a pin in a moment and comes free as soon as the loose end is pulled. Hasluck described the ring version in 1907 as a handy way to make a boat's painter fast to a pier ring for a while; he advised that if a small boat's mainsheet must be made fast at all, which is always somewhat risky, this hitch should be the starting point, because one hard tug on the end frees the sheet immediately. Verrill gave it in 1917 as a hitch almost as quick to make and cast off as a lark's head held with a toggle. Aldridge shows that the ring version can be made permanent by stoppering it, while Dana and Pearl objected in 1921 that a strain jams it so tight that it becomes difficult to untie.
For permanent fastenings or where lives depend on it; the hitch opens if the end is pulled or snagged by accident.
Weakness
It holds well while the standing part is under strain but opens when the end is pulled or caught; Dana and Pearl add that heavy strain can jam it so it is hard to untie.