Slings a plank (a scaffold board or a swing seat) on a single rope so that it cannot twist and tip over in the sling; it is also used to bundle short spars tightly.
MediumNo ABoK numberLoads and everyday jobsCamping and scouting
Slinging a plank (a scaffold board or a seat) on a single rope without the plank turning over in the sling.
When
Unknown; the earliest descriptions consulted are from 1920 (J. Macgregor Smith) and 1921 (Dana and Pearl).
Who devised it
Unknown.
Where the name comes from
'Scaffold' means a builder's staging; the sources describe the hitch for slinging a scaffold plank but do not explain the name itself.
Its story
The scaffold hitch is used to sling a plank on a single rope so that the plank cannot turn over in the sling. It is described in 1920 in the rope pamphlet that J. Macgregor Smith of the College of Agriculture, University of Saskatchewan, prepared for farmers, and in 1921 in Dana and Pearl's engineering bulletin for the State College of Washington; both finish it by tying the rope's two parts to each other with a bowline. Dana and Pearl give two ways of arriving at it and say both are equally good, while Hasluck, in 1907, slings a plank for painting and small repairs in a different way, with a marlinespike hitch. Today scouts also use it in pioneering projects to hang a seat board on a short aerial runway or a rope swing and to bundle short spars tightly.
On a seat or stage that carries a person without suitable rope, supervision and training, and wherever a permanent sling or approved lifting gear is required.
Weakness
Its hold depends on the final bowline and on the rope not slipping off the end of the plank (notches near the ends are recommended); if it carries a person, this app does not replace hands-on training.